Upgrading The Router Software - NETGEAR WPNT834 Reference Manual

To erase the configuration, click the Erase button.
To restore the factory default configuration settings without knowing the login password or IP
address, you must use the Default Reset button on the rear panel of the router. See
Default Configuration and Password" on page

Upgrading the Router Software

Tip: To ensure you are always using the latest firmware, enable the Firmware Upgrade
Assistant feature so that the router will automatically detect a new version of the
firmware on the Internet and alert you to its availability.
This screen appears at login unless you check Do Not Display This Message Again and click Yes.
Figure 6-6
Tip: Before upgrading the router software, use the router backup menu to save your
configuration settings. A router upgrade may revert the router settings back to the
factory defaults. If so, after completing the upgrade, you can restore your settings
from the backup.
The routing software of the WPNT834 router is stored in FLASH memory, and can be upgraded as
new software is released by NETGEAR. Upgrade files can be downloaded from the NETGEAR
Web site. If the upgrade file is compressed (.ZIP file), you must first extract the file before sending
it to the router. The upgrade file can be sent to the router using your browser.
Note: The Web browser used to upload new firmware into the WPNT834 router must
support HTTP uploads. NETGEAR recommends using Microsoft Internet Explorer
or Netscape Navigator 3.0 or above.
Maintenance
Reference Manual for the RangeMax 240 Wireless Router WPNT834
7-7.
v1.0, November 2005
"Restoring the
6-7