Setting Up A Profile To Connect To An Access Point Or Router - NETGEAR WG311v3 User Manual

NETGEAR 54 Mbps Wireless PCI Adapter WG311 v3 User Manual

Setting up a Profile to Connect to an Access Point or Router

Follow these instructions to set up the WG311 v3 Wireless PCI Adapter to connect to a wireless
access point or router.
1. Use the icon to open the Smart Wizard. The Settings page opens.
Figure 2-4
2. Enter the network settings.
a. In the Network Type section, be sure that Access Point (Infrastructure) is selected.
b. In the Profile box, type the name of the profile.
c. In the Network Name (SSID) field select a network or enter the SSID.
Note: You will not get a wireless network connection unless the network SSID
matches exactly the SSID used by the access point.
3. Save your settings in a Profile.
a. Click the Save Profile button.
All the configuration settings are saved in this profile.
b. Click Apply.
c. Click Close to exit the wizard, or Cancel to return to the previous settings.
4. Verify wireless connectivity to your network.
2-6
v3.0, February 2007