NETGEAR WG311v3 User Manual page 42

NETGEAR 54 Mbps Wireless PCI Adapter WG311 v3 User Manual
Table 3-1. Troubleshooting Tips (continued)
Problem
The Smart Wizard keeps asking me to save
settings.
Two WG311 v3 icons are in the system tray. You have an older software version installed on your system
I can connect to the access point, but not
the other computers on the network or to
the Internet.
Viewing the IP address.
No IP address is assigned to the WG311 v3
Wireless PCI Adapter.
3-2
Action
If you change the settings the Smart Wizard offers you the
chance to save the changes. To avoid this prompt, simply click
Apply before you close the Smart Wizard.
and it needs to be removed. See
Software" in Chapter 1
in Chapter 1.
This could be a physical layer problem or a network
configuration problem.
1. Check to make sure that the access point is physically
connected to the Ethernet network.
2. Make sure that the IP addresses and the Windows
networking parameters are all configured correctly. See
the link to "Internet Networking and TCP/IP Addressing:" in
.
Appendix B
3. Restart the cable or DSL modem, router, access point, and
computer.
To view the WG311 v3 Wireless PCI Adapter IP address, click
the WG311 v3 icon to open the Smart Wizard. Then check the
IP address in the About page.
This may occur if you upgraded your WG311 v3 Wireless PCI
Adapter software and did not reboot your system.
• Either restart your computer, or connect to a different access
point.
• It does not usually help to shut down the Smart Wizard or
disable/enable the card.
v3.0, February 2007
"Removing the WG311 v3
or "Upgrading the WG311 v3 Software"