Setting The Hp Ps1 10 Mode - HP PS110 Configuration And Administration Manual

The Status page includes these items:
Device Information
Shows the router's software version, hardware serial number, host name, device description,
and country selection.
Resource Utilization
Indicates the status of the router's resources, including CPU and memory usage.
Security
Displays the current settings for Denial of Service (DoS) and Stateful Packet Inspection (SPI)
features.
When a DoS attack or SPI intrusion (a specific host blocked) is detected, an alert symbol (
displays on the Security line. If you open the Security section, an alert message next to
DOS or SPI indicates the security violation. Click Alert to view the log details on the
System > Log page. Click Clear to remove the alert message from the status page.
Note
The security alert is not supported when the router is operating in Bridge mode.
Wireless
Displays the current settings for the wireless interface, including radio enable, operating
frequency, mode, channel, SSID, MAC address, authentication, and encryption.
WAN
Displays the WAN connection type, status, and IP address assignment.
LAN
Displays the router's local network IP address, MAC address, and DHCP server status.
USB
Displays the current status of a device attached to the router's USB port.
SNMP
Displays the status of the Simple Network Management Protocol feature.

Setting the HP PS1 10 mode

The System > Mode page configures the operation mode of the router. The device supports
the following Router and Bridge modes:
•
Router Mode: The normal router mode that allows connections between a wired LAN and
wireless clients to the WAN Internet connection, such as a cable or DSL modem. This is the
factory set default mode.
•
Bridge Mode: The router operates like an access point, extending a wired LAN to wireless
clients. In this mode there is no WAN configuration, including routing, VPN, NAT, firewall,
and QoS settings; all Internet access features are disabled. In fact, all four LAN ports and
WAN port are bridged together, so the WAN port operates like another LAN port.
20 Managing the HP PS110 system
)