Bay Window Installation; Radiant Face Installation; Accessories Options - Vermont Castings DEF36S2 Installation Instructions & Homeowner's Manual

REMOVE ALL PLASTIC FROM BRASS TRIMS.
DO NOT REMOVE EXISTING FRAME WINDOW ASSEMBLY.
1. Remove existing bottom louvre and hinges from fireplace. (Set aside the four (4) screws). If the fireplace has been
installed with louvres.
2. Remove existing top louvre from fireplace by lifting up and pulling out. (If the fireplace has been installes with louvres).
3. Hang Bay Window unit over existing glass frame.
4. Re-install upper louvre assembly.
5. Bottom brass trim is removeable when fireplace is installed with marble or tile surround which covers the fireplace
bottom.
STEPS TO INSTALL
1. Remove upper louvre assembly by lifting up and pulling out.
2. Remove deflector cabinet top from the fireplace. (Save the screws and deflector cabinet top to re-install into top panel
radiant).
3. Remove bottom louvre assembly from the hinges. (Set aside the four (4) screws).
4. To install radiant face, first remove the screws that come with fireplace on the side of the cabinet corner posts, two on
top and two at bottom of frame window. (Save the screws for installing radiant face in step 5).
5. Insert top and bottom radiant face into slot at bottom and top of fireplace. Fasten top and bottom radiant face in place
using the screws removed from the fireplace in step 4.
6. Re-install defector cabinet top fastens in prepunched screw holes on bottom of panel radiant face.
7. Insert access panel radiant by sliding into slot at the edge of fireplace and push down to secure.
DESCRIPTION
• Remote Control
• Optional Heater
• Cabinet / Mantel
• Ceramic Refractory Kit
• Bay Window

BAY WINDOW INSTALLATION

DEF 33/36 RADIANT FACE INSTALLATION

ACCESSORIES OPTIONS

- 13 -