Checks After Starting Engine; Cooling Water; Warming Up Engine; Electric Start Models - Yamaha F200B Owner's Manual

Operation
be damaged. If the engine will not start
after 5 seconds of cranking, return the
main switch to "
onds, then crank the engine again.
[ECM00192]
EMU36510

Checks after starting engine

EMU36523

Cooling water

Check for a steady flow of water from the cool-
ing water pilot hole. A continuous flow of water
from the pilot hole indicates that the water
pump is pumping water through the cooling
water passages. If the cooling water passag-
es are frozen, it may take a while for water to
start flowing out of the pilot hole.
ECM01810
NOTICE
If water is not flowing out of the pilot hole
at all times while the engine is running,
overheating and serious damage could
occur. Stop the engine and check whether
the cooling water inlet on the lower case or
the cooling water pilot hole is blocked.
Consult your Yamaha dealer if the prob-
lem cannot be located and corrected.
47
" (on), wait 10 sec-
EMU27670

Warming up engine

EMU30037

Electric start models

1. After starting the engine, allow it to idle for
3 minutes to warm up to provide maxi-
mum operating performance and accel-
eration. Failure to do so will shorten
engine life.
2. Be sure the low oil pressure-alert indica-
tor remains off after starting the engine.
NOTICE: If the low oil pressure-alert
indicator blinks after the engine starts,
stop the engine. Otherwise, serious
engine damage could occur. Check
the oil level and add engine oil if nec-
essary. Consult your Yamaha dealer if
the cause for the low oil pressure alert
cannot be found.
EMU36531

Checks after engine warm up

EMU36541

Shifting

While the boat is tightly moored, and without
applying throttle, confirm that the engine shifts
smoothly into forward and reverse, and back
to neutral.
EMU31721

Stop switches

Confirm that turning the main switch to the
G
" " (off) position stops the engine.
Confirm that removing the clip from the en-
G
gine shut-off switch stops the engine.
Confirm that the engine cannot be started
G
with the clip removed from the engine shut-
off switch.
EMU31733
Shifting
EWM00180
WARNING
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
[ECM01831]