Up (Bring Up System) - NEC NX7700i/5080H-32 Operation Manual

2.4.6.15. UP (Bring up System)

m
X
* This command is valid to inactive partitions (DC Off).
Function:
This command is used to turn the system DC power On, initialize the hardware, and boot up the
BIOS. Whether to subsequently boot the OS depends on the BIOS/EFI settings.
(Screen Example)
iSPyz:--->
This command will bring up the specified partition.
Enter partition number (0-7/all/CR=exit) :
Execute OK? (y/[n])
UP command was accepted. All partitions will run soon.
mm/dd/yyyy HH:MM:SS 0------- System initialization started. (SPFW:Rxx.xx)
[iSP0m:INFO.2094] partition 0 : turning on POWBAY(s)...
:
mm/dd/yyyy HH:MM:SS 0------- System initialization completed. (SPFW:Rxx.xx)
[iSP0m:INFO.2129] partition 0 : handed off the control to BIOS.
(Description)
Description
No.
(a)
(b)
(c)
(d)
End of SEC2
b u
<ENTER>
up
<ENTER>
y
(DIPSW = 00000000)
Enter partition number.
If "all" is specified, all the existing partitions are the target of this command.
A confirmation message appears.
If you are sure to continue, enter "y."
If the first 1 byte of the BIOS virtual DIPSW is not zero, the following confirmation
message will appear:
Partition x BIOS virtual DIPSW is ON.(DIPSW=xxyyyyyy) Continue? ([y]/n)
If you are sure to continue the boot process, enter "y." If you wish to abort, enter
"n."
A "UP command accepted" message appears.
The actual boot is performed in the background.
Shows boot progress in the background.
<ENTER>
all
Description
2-93
Base Module
Description
No.
(a)
(b)
(c)
(d)
855-900547-200