Table of Contents
Advertisement
Brute
B
TM
RUTE. BOILERS AND VOLUME WATER HEATERS, 1,000 & 1,200 MBTU/h
9.4
Installation Jobs
Note – To install your system, you will not need to do
all of the installation jobs listed here. Please refer
to Section 9.3 for a list of specific installation jobs
necessary to install your system.
Job A – Note for Systems Using Common
Venting
If multiple Brute's share a single vent, the system
must be engineered by a competent venting
specialist. The design involves the selection of
draft-inducing equipment, hardware and controls
to properly balance flue gas pressures. Do not
common vent Brute's unless the vent system meets
this requirement. Brute's are never permitted to
share a vent with Category I appliances.
Job B - Naming the Controllers
(This is an individual function – do this for each of the
controls. Use the separate Touch Screen on each boiler.)
Each boiler includes two separate controls, as
shown in Fig. 48. In a system with four boilers, there
will be eight separate controls. See Fig. 49. The
first job is to name each of these controllers.
1.
We will start by entering a name for the first
controller in the line – the Primary controller on
Boiler 1. Start at the "Home" screen. Press
the icon for the Primary control.
Fig. 52 – 'home' screen
2.
The system will present the Status Summary
screen for that controller. See Fig. 53.
Fig. 53 – Status Summary Screen
3.
Select the "Configure" button in the bottom
left-hand corner of the display. Figure 54
shows the Configuration menu.
Fig. 54 – Configuration Menu
4.
Select the line for System Identification and
Access.
Fig. 55 - System Identification and Access
5.
Go down to the line for Boiler Name to change
the name of the control. In this example,
we are working with the Primary control on
Boiler 1, so the name here should be "Boiler
1 Primary." To change the entry, press on
the line for Boiler Name. The system will
Page 53
Advertisement
Table of Contents
Troubleshooting
