Table of Contents
Advertisement
Brute
B
TM
RUTE. BOILERS AND VOLUME WATER HEATERS, 1,000 & 1,200 MBTU/h
Section 1
GENERAL INFORMATION
1.1
Introduction
This manual includes information which will help you
to install, operate, and maintain the Brute 1000 &
1200 systems. Please read this manual completely
before proceeding with the installation. If you have
any questions regarding this equipment, please
consult the Bradford White factory, or a local factory
representative. Many operating problems are caused
by improper installation.
Touch Screen Display
(behind the plastic cover
which slides downward)
Pressure and
temperature
gauge
Power switch
Brute 1000 & 1200 units must be installed
in accordance with the procedures detailed
in this manual, or the Bradford White
warranty will be voided. The installation
must conform to the requirements of the
local jurisdiction having authority, and, in
the United States, to the latest edition of
the National Fuel Gas Code, ANSI Z223.1/
NFPA54. In Canada, the installation must
conform to the latest edition of CSA B149.1
Natural Gas and Propane Gas Installation
Code, and/or local codes. Where required
by the authority having jurisdiction, the
installation of Brute 1000 & 1200 units
must conform to the Standard for Controls
and Safety Devices for Automatically
Fired Boilers, ANSI/ASME CSD-1. Any
modifications to the boiler, its gas controls,
or wiring may void the warranty.
WARNING
If field conditions require modifications, consult
the factory representative before initiating such
modifications.
1.2
About the Brute's
Touch Screen Display
The Brute 1000 & 1200 have an advanced control
system which can perform many functions. This is
part of the reason why the Brute can deliver such
outstanding performance. You can access the
control system using the 'Touch Screen Display'
(see Section 8). There are several "branches" in the
control software, and many different display screens.
For clarity, throughout this manual we have made a
special effort to show you how to reach each of the
important setup and operating functions. We have
done this in two ways:
•
In many cases, we have shown you the actual
touch screen display that you will see while
performing a function.
•
Sometimes, instead of showing the screens,
we have just listed the series of choices you
should make in order to reach the section you
want.
The arrangement of the control software is actually
quite logical, and after you have worked with it a bit,
you will not have any problems "finding your way
around." We just want to give you some help with
the first part of the process, when you are "getting
used to" the control system .
Later in this manual, we will detail information on the
setup and operating procedures. There are a couple
of concepts you will need to understand right from
the start.
•
Each boiler has two controllers (internal
electronic burner controllers) and two burners,
as shown in Figure 1.
•
A single Touch Screen is used to communicate
with these two controllers.
Boiler 1
Touch
Primary
Screen
controller
Gas
valve
Gas
valve
Secondary
controller
Figure 1. Control Arrangement in a Single-Boiler
Page 1
Primary
burner
Secondary
burner
Advertisement
Table of Contents
Troubleshooting
