Operation; General Controls - NEC XL-6500 User Manual

1 2 3 4 5 6
1 2 3 4 5 6

3.OPERATION

1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
1 2 3 4 5 6
This section describes how to select a computer or video source and how to adjust the picture and sound,
register a new signal and other settings and adjustments for set-up

General Controls

Before you turn on your MultiSync Hivid 6500 Projector ensure that the computer or video source is turned
on and that your lens cap is removed.
1. Turn On The Projector
The breaker switch and the main power switch are on the back panel of the MultiSync Hivid 6500
Projector. By turning these switch on, the projector will go into its standby mode and the POWER ON/
STANDBY indicator will glow red. Only after you press the 'On' button on the remote control or projector
cabinet will the POWER ON/STANDBY light turn to green and the projector become ready to use.
2. Select The Computer Or Video Source
Press the INPUT button on the remote control to display the image. Or press the Operate button on the
remote control and use the Source Selection to select your video source: Video, S-Video, RGB or Y/Cr/
Cb.
NOTE: When the message "New Signal" is displayed, register the signal in the Source Registry menu.
3. Adjust The Image and The Sound
Press the PIC CTL button on the remote control or use the Operate-Picture Control menu to adjust the
picture. Press the SOUND CTL button on the remote control or use the Operate-Sound Control menu to
increase or decrease the volume.
4. Turn Off The Projector
First press the POWER button on the remote control or the projector cabinet. The STANDBY light will
glow. Allow the fan to cool the projector for three minutes. This will extend the life of the lamp. Then turn
off the main power switch on the back panel. The power light will go out. Last turn off the breaker switch
on the back panel.
IMPORTANT:
• The projector should be unplugged if it will not be used for an extended period.
• If you want to turn off the image briefly (five minutes or less), press the PIC MUTE button instead
of turning the projector off and on.
• The projector will display a message "No Signal !!" if no input signal is present.
• Do not turn the projector off and then immediately back on. The Projector needs to cool down for
three minutes before it is powered on again.
CAUTION: Do not unplug the projector or turn off the main power while the cooling fan is on and the
"--" on Two Digit display is blinking for three minutes.
26