Screen Size And Projection Distance - NEC XL-6500 User Manual

Screen Size and Projection Distance

1. Place your projector on a flat level surface at the
optimal distance from the screen or wall so you
realize the size image you want. (Avoid having
bright room lighting or sun light directly on the
screen or wall where you'll be projecting the
image.)
2. Connect the power cable, remove the lens cap and
turn the projector on. (If no input signal is avail-
able, the projector will display a black screen.)
3. Ensure that the projector is square to the screen.
4. Move the projector left or right to center the image
horizontally on the screen.
5. To move the projected image up or down, select the
Lens Control from the Operate menu.
6. Adjust the focus using the Lens Control on the
Operate menu.
7. Increase or reduce the size of the projected image
by using the ZOOM/PAN button on the remote
control.
Ceiling Installation
Installing your MultiSync Hivid 6500 Projector
on the ceiling must be done by a qualified
technician. Contact your NEC dealer for more
information.
Do not attempt to install the projector yourself.
The following shows the proper relative posi-
tions of the projector and screen. Refer to the
table to determine the position of installation.
Install in such a way that the projector and
screen are positioned in the proper direction and
at the proper angle. If not, the projector' s
performance will be affected and its reliability
will decrease. Be sure to position the projector
properly.
The manufacturer will not be held responsible
for any problems occurring when the projector is
not installed in the proper position.
If your projector is mounted on the ceiling and
your image is upside down, use PJ ORIENTA-
TION on the ADJUST-SETTING Menu to
correct the orientation. (See page 59.)
Projector
Projection distance
Lens center
Vertical offset
Screen center
17
2.INSTALLATION
Projector
Screen
Screen center
Lens center
Screen
26.93''
(684mm)
11.61''
(295mm)