Samsung SND-3082 User Manual page 18

overview
inside
Item
Network Port
a
Alarm In / Out
b
terminals
SD Memory Card
c
Compartment
Reset Button
d
18_ overview
Used to connect a PoE or Ethernet cable.
Alarm in/out terminals can be configured as follows:
- ALARM IN : Used to connect the alarm input signal.
- ALARM OUT : Used to connect the alarm output signal.
- ALARM COM : Common port where the alarm output signal is connected.
- GND : Used for earth-grounding.
Compartment for the SD memory card.
Resets the camera settings to the default.
Press and hold for about 5 seconds to reboot the system.
If you reset the camera, the network settings will be adjusted so that
J
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
3
4
Description