Digital Dubbing - Panasonic PV-GS19 Operating Instructions Manual

STEREO: Stereo Sound (main sound and sub
sound)
L: Left channel sound (main sound)
R: Right channel sound (sub sound)
• If you dub a tape recorded at the [12bit] selected
as the [ AUDIO REC] on the [
Sub-Menu, playback sound becomes stereo
sound regardless of the [
[ 12bit AUDIO] is set to [MIX].
Playing Back a Card
• While the data on a card is playing back, do not
operate the Mode Dial.
• If a blank (nothing recorded) Card is played, the
screen becomes white.
• If you attempt to play back file recorded in a different
format or file data is defective, the whole display
becomes bluish and the [UNPLAYABLE CARD]
Indication may appear as a warning.
• When the Access Lamp is lit, do not insert or remove
a card.
• When playing back a picture recorded on other
equipment, its size and that of this Camcorder may
appear differently.
• It takes time to display the file depending on the
number of pixels of the file.
• When playing back a file recorded on other
equipment, the date and time display is different
from when it was recorded.
• When playing back a picture recorded on other
equipment, the picture may not be played back or
the quality of pictures may be deteriorated.
• When playing back a non standardized file, the
Folder File Number may not be displayed.
Slide Show
• Playback time may take longer than usual depending
on the picture.
Deleting the Files Recorded on a Card
• When [CARD FULL] is shown during recording,
switch to the Picture Playback Mode and then delete
unnecessary files.
• If there are no files to delete, insert a new card.
• If files conforming to DCF standard are deleted, all
the data related to the files will be deleted.
DPOF
• DPOF setting made on another camera may not
be recognized by Camcorder. Perform the DPOF
Settings on your Camcorder.
• Verifying the DPOF Settings may take a little time.
Wait until the Card Access Lamp goes out.
Others
• The Lock Setting carried out by this Camcorder is
• The SD Memory Card has a write protection switch
SETUP]
AUDIO OUT] setting if
• Whenever plugging in the S-Video cable, plug in the
• Use the AC adaptor to avoid battery depletion.
• If you press the [PHOTO SHOT] Button without
• The blank section of a tape cannot be dubbed.
• Sounds sent through the DV terminal cannot be
• If a tape has a non-recorded portion when the tape
• In the case of importing data recorded with Audio
• Do not plug or unplug the DV Cable during dubbing,
• Regardless of the menu settings on the recorder,
• The images on the recorder monitor may be
• Even if you use a device equipped with DV
• Date or other information to be displayed cannot be
Lock Setting
only effective for this Camcorder.
on it. If the switch is moved to the [LOCK] side, you
cannot write to or format the Card. If it is moved
back, you can.
Playing Back on Your TV
AV cable, too.
Recording from a Tape onto a Card
pausing, blurred pictures may be recorded.
Audio Dubbing
dubbed.
is dubbed, images and sounds may be disturbed
when this portion of the tape is played back.
Dubbing to a PC using the PC's software, only the
original sound (ST1) may be imported, depending on
the software.
Using the DV Cable for Recording

(Digital Dubbing)

or the dubbing may not be completed properly.
digital dubbing is carried out in the same mode as
the [AUDIO REC] mode of the playback tape.
disturbed, but it does not affect the recorded images.
Terminals such as IEEE1394, you may not be able
to perform Digital Dubbing in some cases. For more
information, see the instructions for equipment
connected.
displayed if the software of the connected equipment
does not support the display function.
67