Internal Effects; Rear Panel - Alto TMX160DFX Quick Start Manual

INTERNAL EFFECTS

48. PRESETS Control - Adjust this knob to select the internal effect you want to use.
49. VARIATIONS Control - 16 variations for each preset to further adjust the internal effects.
50. DFX MUTE Switch & PEAK LED - Activates/deactivates the internal effects. This LED lights
up when the input signal is too strong. When the effect module is muted, this LED also lights
up.

REAR PANEL

51. POWER ON/OFF Switch - Turns
the main power ON and OFF.
52. AC Inlet with FUSE Holder -
Connect the mixer to an AC power
outlet with the supplied AC cord.
Please check the voltage available
in your country and how the
voltage for your mixer is configured before attempting to connect the
mixer to the main AC.
53. VENTS - These vents are used for ventilation and heat dissipation.
54. SPEAKERS Jacks These jacks are used to connect speakers.
Note: In order to avoid damage to the built-in amplifier, pay attention to the
allowed impedance of the speaker. Very low load impedances may damage
the amplifier.
52 51
6
53
54
1. VOCAL 1
2. VOCAL 2
3. LARGE HALL
4. SMALL HALL
5. LARGE ROOM
6. SMALL ROOM
7. PLATE
8. TAPE REVERB
9. SPRING REVERB
10. MONO DELAY
11. STEREO DELAY
12. FLANGER
13. CHORUS
14. REVERB+DELAY
15. REVERB+FLANGER
16. REVERB+CHORUS
48
49
50