Power Led; Solo Mode Switch; Main Mix Level; Phones/Control Room - Alto AMX-180 User Manual

4.30 POWER LED

This LED indicates when the power is on in your AMX-180/AMX-180FX.

4.31 SOLO MODE SWITCH

This button provides two modes: up for PFL (Pre-Fader-Listen) mode, down for AFL (After-Fader-Listen) mode.
Engage the button, the output signal of soloed channel will follow the TRIM, EQ, FADER and PAN/BAL control,
and the SOLO ACTIVE LED illuminates.
Release the button to enter into PFL mode, the output signal of soloed channel is unaffected by the PAN/BAL
and FADER control.

4.32 MAIN MIX LEVEL

These faders set the amount of signal sent to the Main Output and the Tape Output.

4.33 PHONES/CONTROL ROOM

This fader sets the amount of signal sent to Control Room /Phone output.

4.34 ALT 3-4 TO MAIN MIX

Engaging this switch allows you to combine the ALT 3-4 output with the MAIN MIX, and feeds ALT 3-4 signal
into Main output.
4.35 2 TK TO MAIN MIX
Engaging this button to route the 2 TK IN signal into the Main Mix output.

4.36 CONTROL ROOM SOURCE

You can choose to monitor any combination of MAIN MIX, ALT 3-4 and 2 TK IN via these MATRIX switches.
The ALT 3-4 is additional stereo mix bus, 2TK IN is the stereo signal coming from the TAPE IN jacks.
These stereo signals will be delivered to the CONTROL ROOM/PHONES by engaging these switches. If no
switches are engaged, there will be no signal at these outputs.
Note: when the channel's SOLO switch was engaged, then the SOLO signal will replace other signals, and also
be sent to the CONTROL ROOM/PHONES.

4.37 24 BIT DIGITAL EFFECTS (For AMX-180FX Model)

- PRESETS CONTROL
Adjust this knob to select the right effect you wish to perform. There are total 16 options for you: several
kinds of reverb, mono and stereo delay, modulation effects, and versatile two-effect combination.
- VARIATIONS CONTROL
Since you have selected the preferable effect, the next step, please go with the fine consideration, there
are also total 16 variations for each preset. Each variation has been designed modifying several parameter.
- DFX MUTE SWITCH
This switch is used to activate/deactivate the effect facility. Sometimes, you can also use the DFX FOOTSWITCH
for convenient operation.
- PEAK LED
This LED lights up when the input signal is too strong. In case of the digital effect module being muted, this LED
also lights up.
32
33
34
35
36
37
38
39
40
41
42
13