Required Equipment - NEC NEAX IPS NWA-008869-001 Installation Manual

REQUIRED EQUIPMENT

This table shows the equipment required when providing the In-Skin Router.
EQUIPMENT
PN-RTA (RTA)
PZ-M649 (DTI)
PZ-M650 (DTI)
PZ-M623 (ETHER)
PC*
MAT CA-P
or
MAT CA-R
or
MAT CA-T
HUB*
• 10BASE-T cable
(TIA/EIA category3 or
larger)*
• 100BASE-TX cable
(TIA/EIA category5)*
T1 Network cable*
E1 Network cable*
*: Prepared by customers
Required Equipment for In-Skin Router
DESCRIPTION
In-Skin Router Card
T1 Digital Trunk Interface (1.5
Mbps) Card
E1 Digital Trunk Interface (2
Mbps) Card
Ether Control (10BASE-T)
Card
Local Console
MAT cable with 25 pin D-SUB
connector (4 m [158 inch])
MAT cable with 25 pin D-SUB
connector (2 m [79 inch])
MAT cable with 9 pin D-SUB
connector (2 m [79 inch])
10BASE-T/100BASE-TX
cable
Twisted pair cable with RJ-48C
connector
Twisted pair cable with RJ-48C
connector
QUANTITY
1-8
1-8
1-8
1-8
1
1
As required
As required
As required
As required
– 17 –
CHAPTER 2 INSTALLATION
REQUIRED EQUIPMENT
REMARKS
Maximum 8/PIM
Mounted on PN-RTA Card
Mounted on PN-RTA Card
Mounted on PN-RTA Card
Cable between the In-Skin
Router and local console.
Cable between PN-RTA/PZ-
M623 and IP network
Cable length:
Maximum 100 m (328 ft.)
Cable between PZ-M649 and
Digital Private Line (T1)
Cable length:
Maximum 200 m (655 ft.)
for DSX-1
Maximum 1758 m (5764 ft.)
for DS-1
Cable between PZ-M650 and
Digital Private Line (E1)
Cable length:
Maximum 400 m (1310 ft.)
NWA-008869-001 Rev.1.0
NOTE
NOTE
atch2001.fm