Black & Decker FP550 Instruction Manual page 9

Place the bowl onto the lower power outlet so
that the unlocked padlock symbol aligns with
the arrow. Rotate the handle to the right until
the bowl is locked into position and the locked
padlock symbol aligns with the arrow.
Slide the required accessory onto the spindle.
Place the ingredients into the bowl.
Place the lid onto the bowl with the feeder
tube to the right of the lid locking slot.
Rotate the lid counter-clockwise, while holding
down the upper power outlet hood, until the
lid locks into the lid locking slot.
The food processor will not operate if the lid is not
correctly locked into position.
Citrus juicer (fig. I)
Check that the upper power outlet hood is
closed.
Place the bowl onto the lower power outlet so
that the unlocked padlock symbol aligns with
the arrow. Rotate the handle to the right until
the bowl is locked into position and the locked
padlock symbol aligns with the arrow.
Place the filter basket onto the bowl with the
locking spur on the basket to the right of lid
locking slot.
Rotate the basket counter-clockwise until the
spur locks into the locking slot.
Fit the cone into the hole in the filter basket.
For large pieces of fruit, place the large cone
over the smaller cone.
Blender attachment (fig. J) (FP600 only)
Use the blender attachment for fine blending of
raw ingredients and blending of cooked
ingredients to a very smooth consistency.
Raise the upper power outlet hood.
Place the ingredients into the blender jug.
Lock the lid by aligning the locked padlock
symbol with the arrow. The spur on the lid
must be fit into the locking slot on the top of
the jug's handle.
If the lid is not properly positioned, the appliance
will not operate.
Once the blender jug and lid are locked into
place on the motor unit, the lid cannot be
removed.
Place the blender onto the upper power outlet
with the unlocked padlock symbol aligned with
the arrow. Rotate the jug counterclockwise so
that the locked padlock symbol and the arrow
are aligned. The jug is now in the proper
position.
To remove the jug, rotate clockwise.
Grinding attachment (fig. K) (FP600 only)
Use the grinding mill for fine chopping or grinding
of small pieces. The grinding mill is ideal for nuts,
coffee, herbs and spices.
Raise the upper power outlet hood.
Place the ingredients in the mill and lock the
lid into position.
Place the grinding mill onto the upper power
outlet with the unlocked padlock symbol aligned
with the arrow.
Turn the mill counter-clockwise until the locked
padlock symbol is aligned with the arrow.
The mill is now in position.
To remove, turn the mill clockwise
USE
Do not run the appliance for periods in
excess of 3 minutes (whisk, citrus juicer) or
2 minutes (other attachments).
Operating the appliance
Fit the desired attachment.
Plug the appliance in.
Switch the appliance on: Rotate the dial to
select the desired speed setting (1- 5).
The setting can be varied during processing.
For greater control, rotate the dial to the P position
for pulse control, which will permit intermittent
bursts of power.
Switch the appliance off: Rotate the dial to the
'0' position.
Please be aware of the following safety
features when operating the appliance:
When using the lower power outlet: The upper
power outlet hood must be locked into place
and the processor lid must be locked into the
lid locking slot.
E N G L I S H
9