Problems - Melitta Caffeo Passione Operating Instructions Manual

Problems

Requirement: The appliance is ready for operation.
1. Remove the water tank.
2. Remove the water filter (see Fig. 19).
3. Insert a new water filter (see section Inserting the water filter on
page 94).
Permanently de-registering the water filter
If you have removed an inserted water filter and want to continue operat-
ing the appliance without a water filter, de-register the water filter from the
appliance:
1. Remove the water tank.
2. Remove the water filter (see Fig. 19).
3. Fill the water tank.
4. Press the "Service" button and also the "Large cup" direct key for longer
than 2 seconds.
» The water filter is de-registered.
» The water hardness is reset to the water hardness that the appliance
had stored prior to inserting a water filter.
5. Adjust the water hardness if necessary (see section 7.4 Setting the water
hardness on page 81).
9 Problems
If the actions listed below fail to rectify the problems or other problems not
listed here occur, contact our hotline (local rate).
Germany: +49 571/ 861 900
Austria: +43 810/ 100 500
Switzerland: +41 62/ 388 98 48
Luxemburg: +32 9/ 331 52 30
Problem
Coffee only emerges as
drips from the outlet.
96
Cause
Grinding fineness is
too fine.
Appliance is soiled.
Appliance is covered
inside with limescale.
Action
Set a coarser grinding fine-
ƒ
ness (see section 7.7 one
page 84).
Clean the brewing unit (see
ƒ
section 8.2 one page 85).
Run the cleaning pro-
ƒ
gramme (see section 8.4 one
page 88).
Run the descaling pro-
ƒ
gram (see section 8.5 one
page 90).