GE JGS968 Owner's Manual page 26

Using the self-cleaning oven.
The oven door must be closed and all controls must be set correctly for the cycle to work properly.
26
How to Delay the Start of Cleaning
Touch the SELF CLEAN STD/LOW pad
once for a 4-hour clean time or twice
for a 3-hour clean time.
A 3-hour self-clean time is
recommended for use when cleaning
small, contained spills. A self-clean
time of 4 hours or longer is
recommended for a dirtier oven.
If a time other than 4 hours or 3 hours
is needed, use the number pads and
enter the desired clean time.
You can change the clean time to any time
between 3 hours and 5 hours, depending
on how dirty your oven is.
Touch the DELAY START pad.
Using the number pads, enter the
time of day you want the clean cycle
to start.
Touch the START pad.
After a Clean Cycle
You may notice some white ash in the
oven. Wipe it up with a damp cloth after
the oven cools.
If white spots remain, remove them with a
soap-filled or plastic scouring pad and
rinse thoroughly with a vinegar and water
mixture.
These deposits are usually a salt residue
that cannot be removed by the clean cycle.
If the oven is not clean after one clean
cycle, repeat the cycle.
The door locks automatically. The display
will show the start time. It will not be
possible to open the oven door until the
temperature drops below the lock
temperature and the LOCKED light goes
off.
When the LOCKED light goes off, you will
be able to open the door.
You cannot set the oven for cooking until
n
the oven is cool enough for the door to
unlock.
While the oven is self-cleaning, you can
n
touch the CLOCK pad to display the time
of day. To return to the clean
countdown, touch the SELF CLEAN
STD/LOW pad.
n If the racks become hard to slide, apply a
small amount of cooking oil to a paper
towel and wipe the edges of the oven
racks with the paper towel.