CE Compliance
This product meets the essential requirements of applicable
European Directives, as amended for CE Marking, as follows:
Low-Voltage Directive (safety)......... 73/23/EEC
Electromagnetic Compatibility
Directive (EMC) ............................... 89/336/EEC
Note
this product for any additional regulatory compliance
information. To obtain the DoC for this product, click
Declarations of Conformity Information at
ni.com/hardref.nsf/
Mechanical Dimensions
Figure 7 shows the mechanical dimensions of the FP-RTD-122
installed on a terminal base. If you are using the cFP-RTD-122,
refer to the Compact FieldPoint controller user manual for the
dimensions and cabling clearance requirements of the Compact
FieldPoint system.
109.5 mm
(4.31 in.)
Figure 7. FP-RTD-122 Mechanical Dimensions
Where to Go for Support
For more information about setting up the FieldPoint system, refer
to these National Instruments documents:
•
FieldPoint network module user manual
•
Other FieldPoint I/O module operating instructions
•
FieldPoint terminal base and connector block operating
instructions
FP-RTD-122 and cFP-RTD-122
Refer to the Declaration of Conformity (DoC) for
91.44 mm
(3.60 in.)
.
14
107.19 mm
(4.22 in.)
ni.com