User Program - Sharp FO-3800M Servise Manual

FO-3800M

2. User program

A. Outline
The user program is used to realize the machine conditions according
to the user's own requirements.
B. Operating procedure
1) Keep pressing the left and right copy density adjustment keys at
the same time at the same time for over 5 sec. (The copy quantity
display turns off. The photoconductor cartridge replacement lamp,
the toner cartridge replacement lamp, and the paper jam lamp
blink. The machine enters the user program mode.) (Ready lamp
OFF)
Operation flow of user program
Press the clear key.
C. Content
Program No Set value
1 0
1
2
3
4
2 0
1
2
3 0
1
2
3
4
5
4 0
1
5 0
1
9 0
1
The set content of currently
set user program mode is
changed.
NO
Another user
YES
NO
program mode is
selected.
Content
OFF Auto clear time setting
This setting is linked with the shift time from the off-line mode to the on-line
30 sec
mode.
60 sec
When the set value is "0," however, the time is 30 sec.
90 sec
120 sec
30 sec Pre-heat mode shift time setting
60 sec
90 sec
2 min Power shut down shift time setting
5 min
15 min
30 min
60 min
120 min
OFF SPF stream mode setting
ON
YES Power shut down YES/NO setting
NO
OFF Paper width detection ON/OFF setting
ON
8 – 14
2) Set the user program number with the value set key (digit of 10).
(The user program number is displayed on the copy quantity dis-
play.)
3) Press the start key.
(The machine enters the program mode set in procedure 2).)
4) Use the value set key (digit of 1) to enter the desired set value.
(The set value is displayed on the copy quantity display.)
5) Press the start button.
(The content set i procedure 4) is stored.)
After entering a user program mode, press the clear key once, and
the other user program numbers are ready to be selected.
To cancel the user program mode, press the left or right copy density
adjustment key.
START (Normal mode)
Keep pressing the left and
right copy density adjustment
keys at the same time for 5 sec.
The machine enters the user
program mode.
(The copy quantity display
turns off;the photoconductor
cartridge replacement lamp,
the toner cartridge replacement
lamp, and the paper jam lamp
blink.
(Ready lamp goes off.)
Set the user program number
with the value set key.
(The user program number
is displayed on the copy
quantity display.)
Press the start key.
(The machine enters the set
program mode.)
Enter the set value
corresponding to the set
content with the value set key.
Press the start button.
(The set content is stored.)
(Ready lamp goes off.)
Do you
Press the left or the
YES
want to cancel the
right copy density
user program
adjustment key.
mode ?