Adjusting The Steering Levers; Adjusting The Height Adjust Pedal - Scag Power Equipment STT61V-25KBD-SS Operator's Manual

4.15 Adjusting the Steering Levers

1. Position the seat to the desired location.
2. While in the operator's position with out the engine
running, move both steering levers forward and
reverse to check for full function control and
comfort.
3. If adjustment of the steering levers is needed, use the
following instructions to adjust.
A. Loosen the tension knob on the lever assembly.
B. Rotate the steering lever forward or backward to
achieve the optimum operating position.
C. Tighten the tension knob and repeat on the
opposite side.
D. While in the operators position, bring the steering
levers out of the neutral lock position and check
to make sure both levers are even before
operating.
TENSION
KNOB
Figure 4-8 Adjusting Steering Levers
TENSION
KNOB
ROTATE
LEVER
20

4.16 Adjusting the Height Adjust Pedal

1. Position the seat to the desired location.
2. While in the operator's position with out the engine
running, push down on the height adjust pedal to
check for full function control.
3. The height adjust pedal can be located in (3) three
different positions for operator comfort and control.
See Figure 4-9.
HEIGHT ADJUSTMENT PEDAL LOCATIONS
Figure 4-9 Height Adjust Pedal Locations
Section 4
390S0140-2