Adjusting The Steering Levers; Adjusting The Height Adjust Pedal - Scag Power Equipment TURF Tiger II STTII-52V-25CH-LP-EFI Operator's Manual

Section 4
DECK RELEASE
LEVER
Figure 4-9. Deck Release Lever

4.16 ADJUSTING THE STEERING LEVERS

1. Position the seat to the desired location.
2. While in the operator's position without the engine
running, move both steering levers forward and
reverse to check for full function control and comfort.
3. If adjustment of the steering levers is needed, use
the following instructions to adjust.
A. Loosen the tension knob on the lever assembly.
B. Rotate the steering lever forward or backward to
achieve the optimum operating position.
C. Tighten the tension knob and repeat on the opposite
side.
D. While in the operator's position, bring the steering
levers out of the neutral lock position and check to
make sure both levers are even before operating.
TENSION
KNOB
Figure 4-10. Adjusting Steering Levers
4. The control handle can also be adjusted in two
different positions. If necessary, remove the two
bolts securing the control handle to the control lever.
Install the handle in the desired position.
4.17 ADJUSTING THE HEIGHT ADJUST
PEDAL
1. Position the seat to the desired location.
2. While in the operator's position without the engine
running, push down on the height adjust pedal to
check for full function control.
3. The height adjust pedal can be located in three (3)
different positions for operator comfort and control.
See Figure 4-11.
25
TENSION
KNOB
ROTATE
LEVER
R