Removing Clogged Material; Moving Mower With Engine Stopped; Recommendations For Mowing - Scag Power Equipment STT61V-25KBD-SS Operator's Manual

4.10 REMOVING CLOGGED MATERIAL

ROTATING BLADES
NEVER PUT YOUR HANDS INTO THE DISCHARGE
CHUTE FOR ANY REASON! Shut off the engine
and remove the key and only then use a stick or
similar object to remove material if clogging has
occurred.
1. If the discharge chute becomes clogged, shut off the
engine and remove the ignition key. Using a stick or
similar item, dislodge the clogged material. Then
resume normal mowing.
4.11 MOVING MOWER WITH ENGINE
STOPPED
To "free-wheel" or move the mower around without the
engine running, place the dump valve levers in the FREE-
WHEEL position (Figure 4-2). Disengage the parking
brake and move the mower by hand. The dump valve
levers must be returned to the DRIVE position and
torqued to 10ft/lbs to drive the mower.
DUMP VALVE
CONTROL
Figure 4-2 Dump Valve Control

4.12 RECOMMENDATIONS FOR MOWING

1. Do not mow with dull blades. A dull blade will tear
2. The discharge chute must not be removed and must
3. Cut grass when it is dry and not too tall. Do not cut
4. Keep mower and discharge chute clean.
5. When mowing wet or tall grass, mow the grass twice.
6. Use a slow travel speed for trimming purposes.
7. Operate the engine at full throttle for best cutting.
2007 STTDVC
8. Use the alternate stripe pattern for best lawn
18
grass, resulting in poor lawn appearance and reduced
mowing power.
WARNING WARNING
DO NOT OPERATE WITHOUT DISCHARGE CHUTE, MULCHING
KIT, OR ENTIRE GRASS CATCHER INSTALLED
be kept in the lowest position to deflect grass
clippings and thrown objects downward. Direct the
side discharge away from sidewalks or streets to
minimize cleanup of clippings. When mowing close
to obstacles, direct the discharge away from the
obstacles to reduce the chance of property damage by
thrown objects.
grass too short (cut off 1/3 or less of existing grass
for best appearance). Mow frequently.
Raise the mower to the highest setting for the first
pass and then make a second pass to the desired
height.
Mowing with a lower RPM causes the mower to tear
the grass. The engine is designed to be operated at
full speed.
appearance. Vary the direction of the stripe each
time the grass is mowed to avoid wear patterns in the
grass.
Section 4