Section 4 - Operating Instructions; Controls And Instrument Identification - Scag Power Equipment STT61V-25KBD-SS Operator's Manual

Section 4
CAUTION:
Do not attempt to operate this mower unless you
have read this manual. Learn the location and
purpose of all controls and instruments before you
operate this mower.
4.1 CONTROLS AND INSTRUMENT
IDENTIFICATION
Before operating the mower, familiarize yourself with all
mower and engine controls. Knowing the location,
function and operation of these controls is important for
safe and efficient operation of the mower.
1. Ignition Switch (Figure 4-1). The ignition switch
is used to start the engine and has three positions;
OFF, ON, and START.
WATER TEMPERATURE
MOWER DECK SWITCH
OIL PRESSURE
GLOW PLUG INDICATOR
IGNITION SWITCH
VOLTMETER
OPERATING INSTRUCTIONS
LEFT STEERING
CONTROL
PARKING BRAKE
CONTROL
ENGINE
THROTTLE
CONTROL
FUSES
DUMP VALVE
Figure 4-1 Controls and Instruments
2. Mower Deck Switch (Figure 4-1). Used to engage
and disengage the mower drive system. Pulling up on
the switch will engage the deck drive. Pushing down
on the switch will disengage the deck drive.
3. Glow Plug Indicator (Figure 4-1). Yellow indicator
turns off when the glow plugs have been properly
heated after the ignition switch is turned on.
4. Engine Throttle Control (Figure 4-1). Used to
control the engine speed. Pushing the lever forward
increases engine speed. Pulling the lever back
decreases engine speed. Full back position is the
IDLE position. Full forward is the cutting position.
5. Voltmeter (Figure 4-1). Indicates the condition of
the charging system. When the engine is running, in
normal operating conditions, the needle should be in
the 12 to 14 volt range.
DECK LIFT
13
RIGHT STEERING
CONTROL
CUTTING HEIGHT
ADJUSTMENT
DECK RELEASE
SEAT BELT
FUEL GAUGE
HOURMETER
STT-25KBD2007CONTROLS