Dimensions; Venting; Venting Lengths And Air Terminal Locations - Napoleon Vittoria GD19N Installation And Operation Instructions Manual

FIGURE 1a
34
FIGURE 1d
34

VENTING LENGTHS AND AIR TERMINAL LOCATIONS

Use only Wolf Steel, Simpson Dura-Vent, Selkirk Direct
Temp or American Metal Amerivent venting components.
Minimum and maximum vent lengths, for both horizontal
and vertical installations, and air terminal locations for either
system are set out in this manual and must be adhered to.
For Simpson Dura-Vent, Selkirk Direct Temp and American
Metal Amerivent, follow the installation procedure provided
with the venting components.
For vent systems that provide seals on the inner exhaust fl ue,
only the outer air intake joints must be sealed using red high
temperature silicone (RTV). this same sleant may be used
on both the inner exhaust and outer intake vent pipe joints of
all other approved vent systems except for the exhaust vent
pipe connection to the fi replace fl ue collar which must be
sealed using the black high temperature sealant Mill Pac.

DIMENSIONS

FIGURE 1b
/ "
1
8
GAS
LINE
ACCESS
15
FIGURE 1e
/ "
1
8
9 / "
1
2
5"
2 / "
1
2

VENTING

7" DIA.
4" DIA.
33 / "
1
8
26 / "
3
8
12"
ELECTRICAL
13"
/ "
ACCESS
3
8
33 / "
7
8
1 / "
3
4
The connection between the adaptor for these systems and
the fi replace fl ue collar must be sealed using the black high
temperature sealant Mill Pac (not supplied).
A starter adaptor must be used with the following vent
systems and may be purchased from the corresponding
supplier:
PART 4"/7"
Duravent W175-0053
Amerivent 4DSC-N2
Direct Temp 4DT-AAN
For Simpson Dura-Vent, Selkirk Direct Temp and American
Metal Amerivent, follow the installation procedure found
on the website for your venting supplier:
VENTING SUPPLIER
Simpson Dura-Vent
Selkirk Direct Temp
American Metal Amerivent
FIGURE 1c
21 / "
3
4
19 / "
3
4
10 / "
1
4
20 / "
1
2
FIGURE 1f
9"
7" DIA.
4" DIA.
SUPPLIER
Wolf Steel
American Metal
Selkirk
WEBSITE ADDRESS
www.duravent.com
www.selkirkcorp.com
www.americanmetalproducts.com
W415-0612 / C / 01.25.08
5