Finishing; Glass Door Installation And Removal; Log Placement - Napoleon Vittoria GD19N Installation And Operation Instructions Manual

26
Before the glass door can be removed, the optional front must be removed. The glass door is secured to the top front edge
of the fi rebox and retained by the bottom.
1. Unlatch door
2. Pull handle and rotate 90°.
3. Pivot door slightly and lift out of bottom retainer.
1. Place the door frame face down careful not
to scratch the paint.
2. Center the gasketed glass inside the door
frame with the thick side of the gasket facing
up.
3. Bend the glass retainers located along the
edge of the door frame over the gasket holding
the glass in place. Careful not to break the
glass.
NOTE: Care must be taken when removing and disposing
of any broken glass or damaged components. Be sure to
vacuum up any broken glass from inside the fi replace before
operation.
In order to assemble the log set, the glass door must be
removed, see Glass Door Installation and Removal.
FIGURE 60a-d
1. Place the rear log as shown, ensuring the holes on the
underside are placed onto the 2 pins of the log support.
W415-0612 / C / 01.25.08

FINISHING

GLASS DOOR INSTALLATION AND REMOVAL

DOOR GLASS REPLACEMENT
GASKET

LOG PLACEMENT

BRACKET
FIGURE 58
GLASS
DOOR
FRAME
2. Place the left log as shown, ensuring the hole on the
underside is placed onto the burner pin. This will rest on the
left side of the rear log.
90°
FIGURE 59
GLASS
RETAINERS