Table of Contents
Advertisement
14
GLOWING EMBERS
Tear the embers into small pieces and place on the ported
area of the burner. Care should be taken to shred the
embers into thin, small irregular pieces as only the ex-
posed edges of the fibre hairs will glow. The ember mate-
rial will only glow when exposed to direct flame; however,
care should be taken to not block the burner ports. Blocked
burner ports can cause an incorrect flame pattern, carbon
deposits and delayed ignition. PHAZER
exposed to direct flame.
CHARCOAL EMBERS
Randomly place the embers around the bottom brick pan-
els in a realistic manner but not in contact with the flames.
Keep ember dust away from burner ports to avoid plugging
them.
Fine dust found in bottom of bag not to be used. PHAZER
logs, and embers glow when exposed to direct flame. Use
only certified PHAZER
coal embers available from your Napoleon / Wolf Steel Ltd.
dealer.
22
Ensure that glowing embers sufficiently cover the carry over
ports, highlighted below, to achieve maximum glow.
FIGURE 23
MANTLE INSTALLATION
Combustible mantle clearance can vary according to the
mantle depth. Use the graph to help evaluate the clear-
ance needed. The four-sided top extension piece may be
removed if non-combustible framing is faced with a non-
combustible material.
FIGURE 24
W415-0319 / E / 01.17.07
logs glow when
TM
TM
logs, glowing embers and char-
GLOWING EMBERS
CARRY OVER PORTS
Dashed lines are suitable
mantle sizes and clear-
ances when a non-combus-
tible facing is used.
FIGURE 25
CURTAIN
MESH
TM
The curtain mesh must be kept fully closed during opera-
tion to help prevent accidental burns from occurring.
CURTAIN SUPPORT
HOOD
FIGURE 27
UPPER LOUVRE BRACKETS & HOOD
FIGURE 28
Attach the hood with louvre brackets by pressing the top
flange of the bracket into the clips along the top of the
louvre opening with louvre securing tabs facing out.
NOTE: The protective wrap is best removed when the
assembly is at room temperature but this can be
improved if the assembly is warmed, using a hair dryer
or similar heat source.
HOOD
FIGURE 26
HOOD
The heater must
PLATE
not be used when
the hood is re-
moved.
hood over the lip of
the curtain support
plate.
Hook the
Hide quick links:
Advertisement
Table of Contents
