Symbols - Husky H1301F Operator's Manual

Some of the following symbols may be used on this tool. Please study them and learn their meaning. Proper interpre-
tation of these symbols will allow you to operate the tool better and safer.
SYMBOL
V Volts
A Amperes
Hz Hertz
Alternating Current
Class II Construction
Wet Conditions Alert
Read The Operator's Manual
Eye Protection
Safety Alert
Risk of Bursting
Risk of Fire or Explosion
Risk of Electrical Shock
Hot Surface
Risk to Breathing

SYMBOLS

NAME DESIGNATION/EXPLANATION
Voltage
Current
Frequency (cycles per second)
Type of current
Double-insulated construction
Do not expose to rain or use in damp locations.
To reduce the risk of injury, user must read and understand
operator's manual before using this product.
Always wear safety goggles, safety glasses with side shields, or
a full face shield when operating this product.
Precautions that involve your safety.
Do not adjust regulator to result in output pressure greater than
marked maximum pressure of attachment. Do not use at pres-
sure greater than 135 PSI.
Do not spray flammable liquid in a confined area. Spray area
must be well ventilated. Do not smoke while spraying or spray
where spark or flame is present. Keep compressors as far from
the spraying area as possible, at least 15 feet from the spraying
area and all explosive vapors.
Hazardous Voltage: Disconnect from power source before ser-
vicing. Compressor must be grounded.
To reduce the risk of injury or damage, avoid contact with any
hot surface.
Air obtained directly from the air compressor should never be
used to supply air for human consumption.
6