Frame Rate - Panasonic WV-SFV130 Operating Instructions Manual

–
H.264(1): 1280x960
–
H.264(2): VGA
–
H.264(3): QVGA
–
H.264(4): 160x120
[Transmission priority]
Select a transmission priority for H.264 images from the following.
•
Constant bit rate: H.264 images will be transmitted with the bit rate selected for "Max bit rate (per
client) *".
•
VBR: H.264 images will be transmitted with the frame rate selected for "Frame rate*" while maintaining the
image quality level selected in "Image quality". H.264 images will be transmitted with the bit rate kept within
the maximum bit rate that is set for "Max bit rate (per client)*". The image quality is fixed, and the recording
capacity changes according to the "Image quality" setting and conditions of the subject. When calculation
of recording capacity is needed in advance, use "Advanced VBR".
•
Frame rate: H.264 images will be transmitted with the frame rate selected for "Frame rate*".
•
Best effort: In accordance with the network bandwidth, H.264 images will be transmitted with the bit rate
varying between the maximum and minimum bit rates that are set for "Max bit rate (per client)*".
•
Advanced VBR: H.264 images are transmitted at the frame rate specified for "Frame rate*" while the image
quality is controlled so that the average transmission rate during the period specified for "Control time
period" becomes the bit rate selected for "Max bit rate (per client)*".
•
Default: Frame rate
Note
•
When "Frame rate" or "Advanced VBR" is selected for "Transmission priority", number of users who
can access the camera may be limited more (may become less than 10).

[Frame rate*]

Select a frame rate for H.264 images from the following.
1fps/ 3fps/ 5fps*/ 7.5fps*/ 10fps*/ 12fps*/ 15fps*/ 20fps*/ 30fps*
•
Default: 30fps*
Note
•
When "Frame rate", "Advanced VBR", or "VBR" is selected for "Transmission priority", this setting is
available.
•
"Frame rate*" is restricted by "Max bit rate (per client)*". For this reason, the frame rate may be lower
than the specified value when any value marked with an asterisk (*) is selected. When "VBR" is selected
for "Transmission priority", depending on the settings of "Max bit rate (per client)*" and "Image
quality", transmission of images may periodically be paused. Check the transmission of images after
changing settings.
[Burst tolerance level]
Select how much the bit rate can exceed "Max bit rate (per client)*" by from the following.
High/Middle/Low
•
Default: Low
Note
•
This setting is only available when "Advanced VBR" is selected for "Transmission priority".
•
When "H.264(1)", "H.264(2)", "H.264(3)", or "H.264(4)" is selected for "Recording format", "High" and
"Middle" are unavailable.
11 Configure the settings relating to images and audio [Image/Audio]
Operating Instructions 77