VSS7915/00T & VS79155T | Installation Instructions
•
Identify the top of the mounting box (the tamper-resistant screw
thread is at the bottom).
•
Decide which rear entry hole (big or small) you will use for the
cable and break out the corresponding tab in the mounting box.
•
Mount the metal grommet supplied (if you have chosen the
smaller rear entry point use the rubber grommet supplied).
•
Run the connection cable through the grommet leaving about
15cm sticking out and tighten the metal grommet.
•
Using the four short screws attach the mounting box to the frame
plate.
•
Crimp the supplied connector onto the cable (see section System
Cable).
Raised mount
Top recess
Bosch Security Systems | 2003-11
Four 3.5 x 25mm
screws with plugs
EN | 6
Raised-mounting
surround