Vpn Passthrough Settings - HP R100-Series Configuration And Administration Manual

This page includes the following settings:
VPN Tunnel Parameters
•
Tunnel Type: Select PPTP as the tunnel type.
•
Tunnel Name: Enter a descriptive name for the tunnel. Do not use these characters: ` "
& ' # \
•
Username: Enter the user name for PPTP tunnel. Do not use these characters: ` " & ' # \
•
Password: Enter the password for the PPTP tunnel. Do not use these characters: ` " & ' #
\
•
Confirm Password: Confirm the PPTP tunnel password.
•
Idle Timeout: Set the time after which the tunnel is closed when there is no activity.
PPTP Type Setting
•
PPTP Type: Sets the router to act as the PPTP server or client. When you set the type as a
PPTP Client, you can then enter the Remote Server IP address.
•
Enable Auto Reconnect: For PPTP client connections, you can automatically reconnect
when there is activity after a disconnection.
•
Remote Server: Enter the remote server IP address.
Remote Networking Setting
Enable the remote network setting, and then set the IP address and subnet mask.

VPN passthrough settings

VPN passthrough allows VPN traffic that originates from a VPN client to pass through the
router. For example, if you are not using a VPN that is configured on the router, but are using a
laptop to access a network at another site, configuring VPN passthrough allows that
connection.
VPN passthrough settings 79