Filter Display Indicator Activation - Follett 7CI100A Series Installation, Operation And Service Manual

Filter Display Indicator Activation –––––––––––––––––––––––––––––––––––––
If you purchased your dispenser with a Follett filter, the filter display indicator
activation has been preset at the factory .
If you are using an "after market filter," an adjustment may be made to
activate the "Fresh Filtered Ice & Water" display .
Activating "Fresh Filtered Ice & Water"
1 . Remove the front panel as explained in
Components on page 12
2 . Remove top panel (Fig . 12 .1) .
Note: For _15 Series dispensers, the right side panel must also be
removed .
3 . Remove (1) screw and top of control board enclosure (Fig . 12 .2) .
4 . Locate the DIP switches on the dispenser's control board (Fig . 13) .
Use a fine-pointed object to move the "Filter" DIP switch (DIP switch
#3) to the ON position .
Deactivating the Six-Month Maintenance/Filter Change Reminder
1 . Use a fine-pointed object to move the "PM" DIP switch (DIP switch
#8) to the ON position .
Not used (OFF position)
Ice only
No internal filter
Not used (OFF position)
Not used (OFF position)
15 minute delay
Not used (OFF position)
Six-month PM enabled
Accessing Internal
then refer to Fig . 12 .
OFF ON
Ice & water
Internal filter supplied or to display "Fresh Filtered"
30 minute delay
Six-month PM disabled
Dispenser and Ice Machine 230 V/50 Hz and 220 V/60 Hz
Fig . 12
1
2
Fig . 13
13