Installation
(continued) –––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
9 . Secure unit to wall or cove molding with supplied bracket (Fig . 7) to
prevent tipping .
Note: Fasteners must be supplied by installer .
WARNING!
Freestanding unit must be secured to wall to prevent tipping.
Failure to do could result in personal injury or damage to the
unit.
Optional Leg Accessory Installation
1 . If installing optional 6" Leg Accessory (item# 00956318), tilt or lay
base stand on side and screw each leg into stand (Fig . 8) .
Optional Internal Water Filter Installation
If your dispenser has the internal water filter option, the water filter must be
installed for the dispenser to operate . Because internal components will need
to be accessed for both procedures, Follett recommends installing the water
filter just prior to initial sanitizing .
1 . If installing the optional internal water filter, please complete the
Accessing Internal Components on page 12
steps shown in
before proceeding .
2 . Lift and remove the top panel, set aside (Fig . 9 .1) .
3 . Remove two screws (Fig . 9 .2) and remove left side panel .
4 . Install filter as shown . Turn filter clockwise until it is fully seated
(Fig . 9 .3) .
Dispenser and Ice Machine 230 V/50 Hz and 220 V/60 Hz
Fig . 7
Fig . 8
Fig . 9
1
2
3
11