General Information - Bradford White RG1D Installation & Operation Instructions

This gas-fired water heater is design certified by CSA International under the
applicable American National Standard, Z21.10.1-Latest Edition or CSA 4.1-
Latest Edition, available from CSA International, 8501 East Pleasant Valley
Road, Cleveland, OH 44131-5575, USA.
This water heater must be installed in accordance with local codes. In the
absence of local codes, it must be installed in compliance with the National
Fuel Gas Code, ANSI Z223.1-Latest Edition, or in Canada, Natural Gas
Installation Code, CAN/CGA B149.1-Latest Edition, or Propane Installation
Code, CAN/CGA B149.2-Latest Edition. The warranty for this water heater is
in effect only when the water heater is installed, adjusted, and operated in
accordance with these Installation and Operating Instructions. The
manufacturer will not be liable for any damage resulting from alteration and/or
failure to comply with these instructions.
This water heater is not design certified for installation in a mobile home.
Such an installation may create a hazardous condition and will void the
warranty.
This water heater has been designed and certified for the purpose of heating
potable water. The installation and use of this water heater for any purpose
other than the heating of potable water may cause damage to the water
heater, create a hazardous condition, and void the warranty.
Incorrect operation of this water heater may create a hazard to life and
property and will void the warranty.
Prior to connecting the gas supply line to a gas fired water heater, ensure
that the gas supply line does not have moisture/water or dirt/scale inside
the gas line. Commonly this check is done at the lowest point in the gas
distribution system prior to gas burning appliances.
Do not use this appliance if any external part to the tank has been submerged
in water. You should contact a qualified service technician to inspect the
appliance and to replace any part of the control system including the
combination gas control which has been submerged in water. See the Gas
Connections section of this manual before servicing or replacing a water
heater that has had any external part to the tank submerged in water.
Do not store or use gasoline or other flammable, combustible, or corrosive
vapors and liquids in the vicinity of this or any other appliance.

GENERAL INFORMATION

CAUTION
WARNING
DANGER
4