General Information - Bradford White RE2H50S 1NCTT Series Installation/Operation Instruction Manual

Heat pump water heater
Table of Contents

Advertisement

General Information

READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
For your safety, the information in this manual must be followed to minimize the risk of fire or
explosion, electric shock, and/or to prevent property damage, personal injury, or loss of life.
The warranty on this water heater is in effect only when the water heater is installed and operated in accordance
with local codes and these instructions. The manufacturer of this heater will not be liable for any damage
resulting from failure to comply with these instructions. Read these instructions thoroughly before starting.
This water heater must be installed in accordance with local codes. In the absence of local codes, install this
water heater in accordance with the latest edition of the National Electrical Code.
Incorrect operation of this appliance may create a hazard to life and property and will nullify the warranty.
Do NOT use this appliance if any part has been submerged in water. The plumbing professional responsible
for the installation of this water heater should be contacted to inspect the appliance and to replace any part of
the control system, including thermostat(s), that has been submerged in water.
If the water heater has been subjected to flood, fire, or physical damage, turn off power and water to
the water heater. Do NOT operate the water heater again until it has been thoroughly checked by qualified
service personnel.
• Turn OFF power to water heater if it has been subjected to overheating, fire, flood, or physical damage.
• Do NOT turn on water heater unless it is filled with water.
• Do NOT turn on water heater if cold water supply shut-off valve is closed.
NOTE: Flammable vapors may be drawn by air currents from surrounding areas to the water heater.
Make sure that the rating plate on the water heater is referenced for certainty that the correct voltage is being
supplied to the water heater.
DO NOT store or use gasoline or other flammable, combustible, or vapors and liquids in the vicinity of
this water heater or any other appliance. Keep rags and other combustibles away.
A sacrificial anode(s) is used to extend tank life. Removal of any anode, except for inspection and/or
replacement, will nullify the warranty. In areas where water is unusually active, an odor may occur at the hot
water faucet due to a reaction between the sacrificial anode and impurities in the water. If this should happen,
an alternative anode(s) may be purchased from the supplier that installed this water heater This will minimize
the odor while protecting the tank. Additionally, the water heater should be flushed with appropriate dissolvers
to eliminate any bacteria.
Before proceeding, please inspect the water heater and its components for possible damage. DO NOT
install any damaged components. If damage is evident, please contact the supplier where the water heater
was purchased, or the manufacturer listed on the rating plate for replacement parts.
For Installations in the State of California
For California installation this water heater must be braced, anchored, or strapped to avoid falling or moving
during an earthquake. 6 See instructions for correct installation procedures. Instructions may be obtained from
DSA Headquarters Office, 1102 Q Street, Suite 5100, Sacramento, CA 95811.
WARNING
WARNING
WARNING
IMPORTANT!
3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Re2h65t 1nctt seriesRe2h80t 1nctt series

Table of Contents