Rear Panels - NAD M55 Owner's Manual

Nad digital disc player owner's manual m55

Hide thumbs Also See for M55:

Table of Contents

Identification of Controls

REAR PANEL (EUROPEAN VERSION)

1 IR IN Jack

2 DIGITAL OUT COAXIAL Jack

3 DIGITAL OUT OPTICAL jack

4 MIXED AUDIO OUT (L & R) Jacks

5 5.1 CH AUDIO OUT FRONT L & R Jacks

6 5.1 CH AUDIO OUT CENTER and SUBW (Subwoofer) Jacks

7 5.1 CH AUDIO OUT SURR (Surround Sound) L & R Jacks

8 S-VIDEO & Composite VIDEO OUT Jacks (480i/576i video

resolutions)

9 COMPONENT VIDEO OUT Jacks (480i/576i and 480p/576p, video

resolutions)

NOTES

Connect the optical digital cable (not supplied) firmly so that the configurations of both the cable and the connector match.

The +12V TRIGGER IN jack is a 3.5mm monotype miniature phone jack with the centre pin the 12V signal-sense. We recommend that you use

a good quality cable with shield when attaching the 3.5mm monotype plug so as to prevent false triggering of the amplifier due to electro-

magnetic interference from nearby electronic equipment. The +12V-IN TRIGGER allows you to have an external 12V signal to turn ON the NAD

M55 from standby. This 12V signal must be a continuous 12V signal in order to keep the M55 in the ON state. Once you remove the 12V signal

the M55 will return to standby. Check the specifications of the trigger input terminal the other components to ensure these are compatible with

the M55. All 12V-TRIGGER inputs and outputs on other NAD components with a 12V-TRIGGER feature are fully compatible with the NAD M55's

12V-TRIGGER IN. Before making any connections to any 12V-TRIGGER IN make sure all components are disconnected from the AC mains. If in

doubt over the connections, installation and/or operation of the 12V-TRIGGER IN connection, consult your NAD dealer or sales representative.

Failure to observe the above may result in damage to the NAD M55 and/or any ancillary components attached to it.

The IR IN jack is connected to the output of an IR (infrared) repeater (Xantech or similar), or the IR output of another component to allow control

of the M55 from a remote location. Ask your dealer or custom installer for further details

10 HDMI OUT Jack (480p/576p, video resolutions)

11 VGA OUT Jack (480p/576p, 720p, and 1080i video resolutions)

12 AUTO TRIGGER ON/OFF Switch

13 +12V TRIGGER IN jack

14 SCART/RGB OUT Jack (480i and 576i, video resolutions)

15 Power cord socket

16 POWER ON/OFF

17 RS 232 In/Out Jack

Table of Contents