Dolby Pro Logic Surround Sound - NAD M55 Owner's Manual

DOLBY PRO LOGIC SURROUND SOUND

One can enjoy the high quality sound of Dolby Pro Logic Surround Sound if your A/V receiver is equipped with a Dolby Pro Logic Surround Sound
processor or decoder.
To enjoy Dolby Pro Logic sound
from this DVD player you need the
following:
• DVD recorded in Dolby Pro
Logic format.
• Dolby Pro Logic A/V receiver
equipped with a Dolby Pro
Logic decoder, or Dolby Pro
Logic decoder and power
amplifier
• 5 speakers
Connection example
Front Speaker
(left)
WITH A RECEIVER EQUIPPED WITH A DOLBY PROLOGIC DECODER
Connect the Speakers and receiver equipment the same way as described in Enjoying Dolby Digital Sound. Then connect two channel 75 Ohm audio
cables as above. Refer to that A/V receiver's owner's manual and set the receiver so you can enjoy Dolby Pro Logic Surround sound.
You must select a type is a surround-compatible Downmix (Left-total/Right-total, or Lt/Rt) of the multichannel source suitable for Dolby Pro Logic II,
Dolby Pro Logic IIx, or other matrix decoding. From the Setup OSD, you need to select, Audio, Downmix, and then 'Lt/Rt' for multi-channel matrix
decoding.
WARNING
Do not connect the Digital Audio Output of this DVD player to your receiver unless you are connecting the DIGITAL OUT jack of this DVD player
to an AV decoder that has the Dolby Digital or DTS decoding function. High volume sound may damage your hearing as well as the speakers
(Refer to Selecting Digital Audio Output. (Refer to Initial Setup Settings, Audio)
NOTES
Refer to the owner's manual of your audio equipment as well. When you connect the M55 to other equipment, be sure to turn off the power
and unplug all of the equipment from the wall outlet before making any connections. The output sound of the M55 has a wide dynamic range.
Be sure to adjust the receiver's volume to a moderate listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.
Turn off the receiver before you connect or disconnect the M55's power cord. If you leave the receiver power on, the speakers may be damaged.
CONNECTING TO A SURROUND SOUND SYSTEM
From the
MIXED AUDIO L/R jacks
75-Ohm audio cables
To RCA audio input jacks of
the surround sound receiver
equipped with a Dolby Pro
Logic decoder To audio input
TV
Rear speaker (left)
From S-VIDEO / Component Video /
Composite or SCART
S-VIDEO / Component / Composite
75–Ohm coaxial or SCART cable
To S-VIDEO / Component / Composite or
SCART inputs of the receiver
Centre speaker
TV
Rear speaker (right)
Setup
Front speaker
(right)
21