2-Channel Digital Stereo Sound - NAD M55 Owner's Manual

Nad digital disc player owner's manual m55

Hide thumbs Also See for M55:

Table of Contents

Setup

CONNECTING TO A SURROUND SOUND SYSTEM

2 CHANNEL DIGITAL STEREO SOUND

You can enjoy the dynamic sound of 2 Channel Digital Stereo by connecting this DVD player to a receiver equipped with a digital audio input and

speaker system (right and left front speakers).

From the DIGITAL OUT

(COAXIAL or OPTICAL) jacks

From S-VIDEO /

Component Video /

Composite or SCART

TO ENJOY DIGITAL SOUND

You need to select from the OSD drop down menu, Audio, 'Digital Audio Output', and any of the 'PCM' settings, '96 kHz' or '48 kHz'. If uncertain,

leave the default 'Stream/PCM' and '48 kHz' from the menu. (Refer to Initial Setup Settings, Audio)

NOTES

• Refer to the owner's manual of your receiver as well.

• Before you connect the M55 to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before

making any connections.

• Depending on your Digital sound decoder, the decode rate may 96 kHz or 48 kHz.

• The output sound of the M55 has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate listening level. Otherwise, the

speakers may be damaged by a sudden high volume sound.

• Turn off the receiver before you connect or disconnect the M55's power cord. If you leave the receiver power on, the speakers may be damaged.

To the digital input of an amplifier equipped with either

75-Ohm coaxial cable

75-Ohm coaxial digital input or digital optical input.

or optical cable

S-VIDEO / Component / Composite

75-Ohm coaxial or SCART cable

To S-VIDEO / Component /

Composite or SCART

inputs of the TV.

Table of Contents