Section 1 - General Information; Introduction; Directional Reference; Servicing The Engine And Drive Train Components - Scag Power Equipment STT52V-27CH Operator's Manual

Section 1

1.1 INTRODUCTION

Your mower was built to the highest standards in the
industry. However, the prolonged life and maximum
efficiency of your mower depends on you following the
operating, maintenance and adjustment instructions in this
manual.
If additional information or service is needed, contact
your Scag Power Equipment Dealer.
We encourage you to contact your dealer for repairs. All
Scag dealers are informed of the latest methods to
service this equipment and provide prompt and efficient
service in the field or at their service shop. They carry a
full line of Scag service parts.
USE OF OTHER THAN ORIGINAL SCAG
REPLACEMENT PARTS WILL VOID THE
WARRANTY.
When ordering parts, always give the model and serial
number of your tractor. The serial number plate is
located where shown in Figure 1-1.
SERIAL NUMBER
PLATE LOCATION
Figure 1-1 Tractor Serial Number Plate Location
USE ONLY SCAG APPROVED ATTACHMENTS
AND ACCESSORIES.
Attachments and accessories manufactured by companies
other than Scag Power Equipment are not approved for use
on this machine.
GENERAL INFORMATION
390S0137A
1
Scag approved attachments and accessories:
GC-STT (p/n 9059, 9060, 9039)
GC-STT-CS (p/n 9063, 9064, 9041)
Mulch Plate (p/n 9287, 9288, 9262)
Hurricane Mulch (p/n 9284, 9285, 9267)
STT Hitch (p/n 9242)
STT Bumper (p/n 9256)
STT Suspension Seat (p/n 9270)
STT Lights (p/n 9279)
Tiger Striper (p/n 9269)
Blade Buddy (p/n 9212)
WARNING:
For pictorial clarity, some illustrations and figures
in this manual may show shields, guards or plates
open or removed. Under no circumstances should
your mower be operated without these devices in
place.
All information is based upon product information
available at the time of approval for printing. Scag
Power Equipment reserves the right to make
changes at any time without notice and without
incurring any obligation.
1.2 DIRECTION REFERENCE
The "Right" and "Left", "Front" and "Rear" of the
machine are referenced from the operator's right and left
when seated in the normal operating position and facing
the forward travel direction.
1.3 SERVICING THE ENGINE AND DRIVE
TRAIN COMPONENTS
The detail servicing and repair of the engine, hydraulic
pumps and gearboxes are not covered in this manual;
only routine maintenance and general service instructions
are provided. For service of these components during
the limited warranty period, it is important to contact your
Scag dealer or find a local authorized servicing agent of
the component manufacturer. Any unauthorized work
done on these components during the warranty period
may void your warranty.