Back Panel Layout - EverFocus EZN850 Installation Manual

2. Back Panel Layout

2
3
4
5
1. SD card slot: Slot to insert SD card
2. Reset: Loading factory default configuration by pressing the button, which is
inside this hole. Please insert the keen-edged device to the hole for 10 seconds.
3. Video output: Composite video BNC output socket. Connect Video output only
for installation usage.
4. Terminal Connector: The terminal connector provides the interface to alarm input
& output, RS-485, GND and IR illuminator power source. (please see "2.1
Terminal Connector")
5. Control key selection switch
Switch to OSD to control OSD menu by using the control key or switch to LENS
to adjust zooming and focus by using the control key (please refer to "4.1 Lens
setting" and "5. OSD Configuration" for details).
6. Ethernet RJ-45 port: Connect to LAN via this standard RJ-45 connector.
Yellow indicator light: On means 100Mbps, Off means 10Mbps
Green indicator light: On means link, flicking means active, Off means link fail
7. Power Input Terminal
Connect the appropriate power to each model. N/L is used to connect to power
in. PE is a ground pin. Two models of 24VAC and 100-240VAC are available as
power source of EZN850 camera. N/L and PE apply to 100-240VAC model
only.
Note!! Please do NOT connect 100-240VAC power to 24VAC model. It will
damage the machine.
1
7
EZN850
6
7