Regency Horizon HZ30E-NG10 Owners & Installation Manual page 40

installation
|
40
120 Volt AC power is needed for the fan. The fan can be hard wired if desired.
The outlet should be installed in the receptacle box on the right hand side by a
qualified electrician. The neutral (wider) slot of the polarized outlet should be at
the top.
Unit must be grounded at all times. Do not cut the ground terminal off
under any circumstances.
Follow these instructions for Existing Installations.
1. Shut off the gas and power to the unit.
2. Remove the faceplate, mesh guard, enamel panels (if installed) and the glass
door. (See the manual for detailed instructions)
3. Remove the burner tray cover by lifting it up and out as shown
 Prior to removing the burner – remove crystals, pebbles, spa stones and
inner panels – if installed
4. Loosen 2 screws at the back of the burner
5. Remove the burner by sliding it to the right – then lift out.
6. Remove the valve access plate by removing the 17 outer screws – see
locations below
40 | Regency Horizon ® HZ30E-10 Gas Fireplace
7. Do not remove the screw left of the pilot shield – this secures the
valve tray into position.
8. Maneuver the fan into position in the lower right corner at the base of
the unit.
9. Secure the fan to the base with 2 screws
10. Attach the green ground wire to the ground lug – located in the lower
back corner of the unit.