Table of Contents
Advertisement
Installing the base station and charging cradle
The base station and charging cradle are designed for use in enclosed dry
rooms with a temperature range of +5°C to +45°C.
¤
Place the base station in a central location in your flat or house. Position the
base station and charging cradle on a level, non-slip surface or mount them
on the wall
Please note
u
Pay attention to the range of the base station.
This is up to 300 m in unobstructed outdoor areas and up to 50 m inside
buildings.
u
The range is reduced when eco mode is on (
The phone's feet do not usually leave any marks on surfaces. However, due to
the multitude of different varnishes and polishes used on today's furnishings,
the occurrence of marks on the surfaces cannot be completely ruled out.
Please note:
u
Never expose the telephone to the influence of heat sources, direct sunlight
or other electrical devices.
u
Protect your Gigaset from moisture, dust, corrosive liquids and vapours.
Connecting the base station
¤
First connect the
mains adapter 1.
¤
Then connect the
telephone jack
and insert the
cables into the
cable ducts.
Please note:
u
The mains adapter must always be connected, as the phone will not oper-
ate without mains connection.
u
Only use the mains adapter and phone cord supplied. Pin connections on
telephone cables can vary (pin connections
¢
page 61.
2
2
¢
page 40).
¢
page 57).
First steps
1
1
7
Advertisement
Table of Contents
