Vigor2860Vac / Vigor2860Vn-Plus - Draytek Vigor2860 Series Quick Start Manual

3 . 3 V i g o r 2 8 6
3 . 3 V i g o r 2 8 6
LED
ACT (Activity)
WAN2
Line
USB
DSL
Phone1/Phone2
2.4G/5G
LED on Connector
Left
WAN2
LED
(Giga)
Right
0 V a c / V i g o r 2
0 V a c / V i g o r 2
Status Explanation
Blinking The router is powered on and running
normally.
Off The router is powered off.
On Internet connection is ready.
Off Internet connection is not ready.
Blinking The data is transmitting.
On A PSTN phone call comes (in and out).
However, when the phone call is
disconnected, the LED will be off.
Off There is no PSTN phone call.
On USB device is connected and ready for use.
Blinking The data is transmitting.
On The router is ready to access Internet through
DSL link.
Blinking Slowly: The DSL connection is ready.
Quickly: The connection is training.
On The phone connected to this port is off-hook.
Off The phone connected to this port is on-hook.
Blinking A phone call comes.
Wireless access point with bandwidth of
On
2.4GHz/5GHz is ready.
It will blink slowly while wireless traffic goes
Blinking
through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and will
return to normal condition after two minutes.
(You need to setup WPS within 2 minutes.)
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
8 6 0 V n - p l u s
8 6 0 V n - p l u s
12