Yamaha YP250 5GM2-AE1 2000 Service Manual page 31

H Fasten the wireharness to the
frame with a band and the band
of end on inside of the frame.
I Clamp the radiator reservoir
hose.
J Fasten the wireharness to the
stay with a band and the end of
band on rearside.
K Fasten the speed sensor lead to
the stay.
L Route the front speed sensor
lead and front brake hose
through the clamp on the frame.
(front side: speed sensor lead
rear side: front brake hose)
CABLE ROUTING
M Clamp the speed sensor lead to
the front brake hose. Position the
clamp (locatio of the speed sen-
sor) to front of the upper clamp
and another clamps to outside.
N Through the speed sensor lead
between front brake caliper and
bolt.
O Route the speed sensor lead
through the guide.
P When pull the speed sensor
lead. Don't loose.
21
SPEC
Q Clamp the speed sensor lead
and that caliper tightning bolt
and clamp in parallel with front
fork.
R Fix the starter relay to the foot-
rest board.
S Clamp the radiator reservoir
hose and starter motor lead to
the frame with a plastic clamp.
T Fix the fuse box to the footrest
board.
U Fasten the rodiator reservoir
hose and starter motor lead on
the frame with a plastic clamp.