60: Stereo Dynamic Delay - Korg HAVIAN 30 User Manual

512| Effects for the MIDI Sounds
The "Src" parameter sets the modulation source that resets the LFO. For ex-
ample, you can assign Gate as a modulation source so that the sweep always
starts from the specified point.
"L LFO Phase" and "R LFO Phase" set the phase obtained when the left and
right LFOs are reset. In this way, you can create changes in pitch sweep for
the left and right channels individually.
The effect is off when a value of the modulation source specified in the
"Src" parameter is 63 or smaller, and the effect is on when the value is 64
or higher. The LFO is triggered and reset to the "L LFO Phase" and "R LFO
Phase" settings when the value changes from 63 or smaller to 64 or higher.
60: St. Dynamic Delay (Stereo Dynamic Delay)
This stereo delay controls the level of delay according to the input signal
level. You can use this as a ducking delay that applies delay to the sound only
when you play keys at a high velocity or only when the volume level is low.
Stereo In - Stereo Out
Left
Right
+
a Control Target
Polarity
b Threshold
Offset
c Attack
d Release
e L Delay Time [msec] 0.0...1360.0
f R Delay Time [msec] 0.0...1360.0
g Feedback
High Damp Low Damp
Delay
Feedback
High Damp Low Damp
Delay
FB
Attack, Release
Envelope
Threshold
None, Out, FB Selects from no control, output, and
+, –
0...100
0...100
1...100
1...100
–100...+100
FX Amt
Spread
FX Amt
Out
Control Target
feedback
Reverses level control
Sets the level to which the effect is ap-
plied
Sets the offset of level control
Sets the attack time of level control
Sets the release time of level control
Sets the delay time for the left channel
Sets the delay time for the right channel
Sets the feedback amount