Table of Contents
Advertisement
Clean the carburetor in a well-ventilated area, and take care that there is no
spark or flame anywhere near the working area; this includes any appliance with
a pilot light. Because of the danger of highly flammable liquids, do not use
gasoline or low flash-point solvent to clean the carburetor.
1. Make sure the fuel is shut off.
2. Remove the carburetor.
3. Drain the fuel from the carburetor.
4. Disassemble the carburetor.
5. Immerse all the metal parts in a carburetor cleaning solution.
6. After the parts are cleaned, dry them with compressed air.
7. Blow out the fuel passages with compressed air.
8. Assemble the carburetor
9. Install the carburetor onto the motorcycle.
CAUTION:
1.
The motorcycle will only operate properly if the carburetor top is installed
properly with the mounting screws, cable and choke knob oriented as
shown in figure 43.
Figure 43 Proper carburetor top
installation
rectangular slide indexing pin and
vent elbows.
and
location
of
63
Hide quick links:
Advertisement
Table of Contents
