Cobra 2007 King 50 Service Manual page 18

NOTE:
It's very important to oil your filter consistently each time because varied amounts
of oil will change your carburetor jetting.
4. Apply grease to the black sealing surface of the filter and reinstall as in figure
A2.
5. Squeeze the two finger tabs together on the wire retainer and install into the
airbox while aligning the bottom guiding tabs "legs" with the arrows on the
filter (figures A3 & A4)
Figure A3
6. Push the wire retainer down until it bottoms
CAUTION:
If the side arms do not align with the associated holes it is quite likely that the
legs did not make
Figure A2
it into the
17
Figure A4
holes. Realign and try again.