Cobra 2007 King 50 Service Manual page 16

CAUTION:
Adequate pedal free play is required so that the brake pads do not drag on the
rotor. 1" MINIMUM.
Make sure that the free play locking clip is installed such that one must push
forward, toward the front of the bike, to remove. Otherwise the clip is apt to come
undone while riding.
To adjust (see figure 2b):
1. Loosen the lock nut (10mm).
2. Undo the free play locking clip from around the brake adjustor (plunger),
with your hand by pushing it forward.
3. Slide the pin of the locking free play locking clip from the brake lever
4. Adjust as needed by rotating the clevis on the end of the adjustor
(plunger).
NOTE:
Turning the clevis Clockwise will lengthen the adjustor (plunger), removing free
play from the system, and turning the clevis Counter-Clockwise will shorten the
adjustor (plunger) adding free play to the system.
15
Figure 2b