Cobra 2007 King 50 Service Manual page 63

adjustment. To lower the idle, turn the screw counter-clockwise.
TOP END JETTING:
Indications that the engine is running too rich (too much fuel for the air) are:
• Engine not revving out or blubbering at high RPMs.
• Engine will not 'clean out'
• Wet or black spark plug
NOTE: Before changing jetting be sure that the air filter is properly cleaned and
has the usual amount of air filter oil. An overly dirty air filter can cause the engine
to run rich.
If the engine is running rich on the top end it should be leaned out. Leaning it out
can be done by:
1. Changing the main jet to a smaller number.
2. Raising the needle clip (this lowers the jet needle) one notch at a time on the
slide.
Indications that the engine is running too lean are:
• Engine cutting out on top end.
• Engine overheating and ultimately seizure.
• White spark plug
CAUTION:
It is much safer to operate the engine slightly rich as opposed to slightly lean.
This is because an overly rich engine will just run poorly while an overly lean
engine will seize, potentially causing an expensive top end rebuild and a DNF.
To richen the carburetor:
1. Change the main jet one number at a time (larger).
2. Lower the needle clip (raising the jet needle) one notch at a time until the
engine starts to blubber on the top end, then move the clip back up one notch
or until you get the blubber out.
FUEL MIXTURE SCREW
The smaller brass screw that is towards the front of the engine is a fuel mixture
screw. This screw will also richen and lean your engine more on the bottom and
mid-range. In warmer conditions, turn the screw in. In colder conditions, turn the
screw out. Be sure to keep the carburetor very clean and make sure you don't
have water or dirt in the carburetor bowl. Use automotive carburetor cleaner or
WD-40 to clean the carburetor inside and out.
STOCK CARBURETOR SETTINGS
The 2007 CX50 SR stock carburetor settings from the factory are:
• 60 pilot jet
• 95 main jet
Cleaning the carburetor:
62